A rosin filter bag should be selected against the press manufacturer’s usable platen space and accessory restrictions, not simply matched to the plate’s advertised width and length. A flat bag dimension, a closed bag envelope and a platen dimension describe different things. There is no universal bag-to-plate size ratio that establishes compatibility for every machine.
This checklist is for buyers qualifying replacement consumables or preparing a first bulk order. Start with the machine model and a dimensioned bag drawing. Then approve a representative sample before committing to the purchasing specification.
Separate the three dimensions that appear on a quotation
| Dimension | What to request | What it does not establish |
|---|---|---|
| Flat, empty bag size | Outside width and length, measurement direction, seam inclusion and tolerance | The usable interior or final closed envelope |
| Finished accessory envelope | Closure, seam position and any other accessory dimensions under your approved setup | Permission to use that assembly on a particular press |
| Usable platen space | Machine drawing, usable area, opening and required clearances | Compatibility with every bag carrying a smaller size label |
For example, a bag sold as 3 × 5 inches and a plate sold as 3 × 5 inches are not a verified match. Their nominal dimensions may coincide while seams, closure space and manufacturer restrictions remain unresolved. Ask each supplier what its measurement describes rather than treating the labels as engineering drawings.

Build a compatibility request with both suppliers
Send the press supplier its exact model, revision and the proposed bag drawing. Ask for the permitted accessory envelope and whether the planned material and seam configuration are acceptable. Send that response to the bag supplier so the quotation references the same requirement. If the machine manufacturer cannot confirm compatibility, keep the choice provisional.
In its bag and plate sizing guide, The Press Club treats plate dimensions as an input to selection. Such supplier guidance is useful context, but its recommendations are not an EXTRACTPHYTO fit warranty. A written requirement for your own machine takes precedence over a generic size chart.
- Record dimensions in one unit system, retaining the original supplier units.
- Identify whether seams are inside or outside the specified measurement.
- Include closure and accessory requirements in the drawing revision.
- Request the press maker’s required clearances rather than inventing a clearance allowance.
- Distinguish a dimensional fit review from approval of the intended application.

What EXTRACTPHYTO can quote
EXTRACTPHYTO is a China-based manufacturer with catalogue listings for 2 × 3 inch nylon rosin filter bags and 3 × 5 inch nylon rosin filter bags. These are starting points for a specification discussion, not a promise that either fits your press. Custom requirements should be submitted for written feasibility and commercial confirmation.
The CP3815-1 manual press listing also illustrates why machine and consumable specifications belong on separate lines of a purchase request. Do not infer compatibility from two products appearing in the same catalogue. Its current listing states that the machine is not suitable for food processing; application acceptance must be resolved before purchase.

Approve the sample, then lock the purchasing record
Request a sample quotation after the drawings agree. Check the sample against the stated measurement convention, record the supplier’s item reference and retain the approved drawing revision. Any equipment evaluation should follow the machine manufacturer’s instructions and your own qualification requirements. A sample that looks similar is not evidence that later batches share every specified attribute.
For incoming inspection after selection, use the separate filter bag dimensional-tolerance receiving worksheet. It addresses whether delivered bags meet an agreed specification; this article addresses which specification to agree before ordering.
Request a bag-fit review and sample quotation
Contact EXTRACTPHYTO for a bag-fit review and sample quotation, or email [email protected]. Include your company and reply email, press make/model, platen drawing or dimensions, required bag dimensions and measurement convention, micron specification, seam preference, estimated quantity and destination country/postal code.
If quantity or the final bag size is undecided, send the known requirements and mark the rest for review. Ask the quotation to identify the proposed item, sample arrangement, dimensional tolerances and unresolved fit questions. Sample costs, minimum quantities, shipping and timing require confirmation; they are not assumed here.



